Attorneys spar over RPM pay case
MICHIGAN CITY — The 20 La Porte County sheriff’s deputies and employees who filed suit against the county to recover lost wages from the 2009 RPM Fest brought the complaint on grounds that were “frivolous and unreasonable,” county attorneys claim, and are litigating “in bad faith.”
Read more on The Michigan City News-Dispatch
End Mills provide low-torque, high-rate metal removal. .
Featuring 16-flute design, CYCLO CUT Max-Flute End Mills run at 2,037 rpm and 231 ipm to achieve removal rates up to 8 in.³/min with 25 lb-ft torque and 9 hp. Shallow, radial widths of cut minimize heat transfer to cutting tool for roughing titanium, Inconel, and other high-temperature alloys. Used in conjunction with TrueMill® software, end mills maintain constant angle of engagement …
Read more on ThomasNet
Drill and Tap Machine incorporates milling capability.
Along with 508 x 406 x 394 mm work cube and 660 x 381 mm T-slot table, DT-1 features BT-30 taper spindle that spins to 15,000 rpm and allows tapping at speeds to 5,000 rpm. Standard 11.2 kW vector drive system provides 62 Nm peak torque for milling and boring, while 20-pocket, servo-driven tool changer swaps tools in 0.8 sec. Max cutting feedrate of 30.5 m/min, 61 m/min rapids, and 1 G …
Read more on ThomasNet
Toshiba Debuts Three New HDD Lines
Toshiba has unveiled three new small form factor HDDs. The new drives all spin at 7200 rpm and have 2.5-inch form factors. The drives are not only smaller than 3.5-inch drives, but need less power as well. The new HDDs include the MKxx61GSY family aimed…
Read more on I4U
Please check out our sister sites!
Home pay
Buyer pay
Interest pay
Fee pay
New pay
Childbirth
Teacher State
Post Footer automatically generated by wp-posturl plugin for wordpress.
You must log in to post a comment.